Lumens-technology VC-A20P Manuel d'utilisateur télécharger pdf (Page 16)

English - 15

4.3.2 Controlling VCs with the computer

4.3.2.1 Connecting to one computer for connection between VCs (RS-232 in/out)

<Remark> With RS-232 in/out, at most 7 VCs can be connected.

4.3.2.2

Connecting to one computer for connection between VCs (RS-422)

<Remark> Please refer to 8.2 RS-422 connection for the RS-422 connection instructions.

<Remark> With RS-422, at most 7 VCs can be connected.

4.3.3 Use of VC-A20P with Internet Connection

4.3.3.1 Setup before use

 Connect DVI output to the screen.

 Press [MENU] on the Remote Control to display the OSD menu.

 Shift down to [Ethernet] to modify and confirm the IP address.

DHCP: Enable/disable the dynamic host configuration protocol

IP Address: Confirm or modify the IP address of VC-A20P

Subnet mask: 255.255.255.0

Gateway: Preset 192.168.100.1

[Remark] Please modify the above settings based on the LAN setting of the operating environment. To use

DHCP, please connect the VC-A20P to LAN and then confirm IP address.

 After completing settings, press [MENU] to exit the OSD menu.

 After completing setting and confirming IP address, DVI cable can be disconnected.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

Lumens-technology VC-A20P Manuel d'utilisateur Page 16