Lumens-technology VS-K20 Manuel d'utilisateur télécharger pdf (Page 13)

English - 12

Chapter 4 Menu operation

After powered on, “USER PIN” will show on the controller’s screen. The initial

pin is “111111”.

 Pin Error：When “USER PIN：ERROR” shows on screen, it indicates

wrong pin was input. Enter correct pin to get to next step

 Pin Correct：Screen shows “

1” camera icon and default camera

number. If there is no further operation for long time, screen will

display current time automatically. If still no operations, the controller

will enter sleeping mode.

Enter OSD menu

Press SETUP key.

Screen shows “ADMIN PIN:”. Initial admin pin is “111111“.

4.1 Camera Setting

Set camera ID (Range from 1~255), corresponding protocol, baud rates

and camera address of the target cameras. Then every camera can be

controlled easily by choosing their relative camera ID.

1. Move up / down the joystick, choose “CAMERA SETTING”.

2. Right move the joystick or press ENT key to enter menu “ ：＂.

Press number keys to input camera number (range from 1~255) . If

the input number exceeds this range, the system will show

“ERROR”. After the setting is finished, press ENT key to confirm。

3. “Protocol” Setting Menu. Move up/down the joystick, choose

Protocol ( V / PD)。

< Note > VISCA only works with Camera ID 1~7.

4. Baud rate setting. Move up/down the joystick, choose baud rate,

and right move the joystick or press ENT to confirm.

5. Address Setting. Input number to set camera address (range from

1 2 ... 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Lumens-technology VS-K20 Manuel d'utilisateur Page 13